Propane Patio Heater Fuel Consumption: How to Estimate Gas Use
Use the appliance’s recorded gas consumption and your expected running hours to estimate the fuel needed for an outdoor service shift.

To estimate how much fuel a propane patio heater uses, take the gas consumption listed for the exact model, convert it to kilograms per hour, and multiply by expected running hours. If a venue runs several heaters, calculate each group separately. This gives an estimate for purchasing and scheduling.
Read the consumption line in the model data
Heat output in kW and fuel consumption in grams per hour describe different things. Use the consumption line for your fuel calculation and ask which gas configuration and operating setting that figure represents. When a manufacturer reports a range, ask which end corresponds to the planned operation. For example, Qlima labels its PGU 2013 consumption figure as a nominal rate. Read the same condition on each model you compare.
Estimate fuel per service shift
Divide the listed grams per hour by 1,000. Multiply that result by the number of running heaters and the hours they run. As a planning example, the FS-HSS-RS-XX lists 850 g/h. Two units running for three hours at that listed rate would use about 5.1 kg of fuel in total. If one of the units only ran for the final hour, the same assumptions would give 3.4 kg instead.
The compact FS-LFH-E-XX lists 500 g/h. Its published data provides a second consumption example. Confirm the destination fuel configuration for this model before using the figure in a propane quote. Use separate estimates for busy shifts, partially occupied shifts and the planned number of operating days.
Verify the configuration before planning replenishment
Ask for the exact fuel, the model’s approved cylinder and regulator specifications if applicable, and the operating condition behind the consumption data. Confirm the expected amount of usable fuel with the gas supplier before calculating cylinder change frequency. Review the selected model documents and local requirements with the installer or venue team.
Send the figures with your inquiry
Include the model code, destination, number of units and an example shift with the hours each group normally runs. If you have a supply quotation, compare costs using its actual unit of sale and the same consumption assumptions. Browse FirstSight gas models or ask FirstSight to confirm the configuration.
